Journal Entry
 |
Visit Wilbur Engelsma's Profile. Subscribe to this Journal: 
What is RSS?
There are 49 entries in this Journal. Status: Silver Member  Location: Broomfield, CO, USA |
|
Hood Repaired
Created on 2008-09-01 14:50:16
The last piece of sheetmetal to be worked on is the hood. There were two punched in areas close to the bulkhead end, and the front lip was also damaged. The hood is now repaired, and ready for some build primer and blocking. I should have taken a picture before I started, but looks like I forgot.
Click the thumbnail to view image:
Hood
Hood
Hood
Hood
Summary of Previous Journal Entries
Showing previous 10 journal entries:
| Title | Date | #Pic | #Cmt | Excerpt |
|---|---|---|---|---|
| Hood (bonnet) Seams | 2008-08-24 | 3 | Since I welded the fenders on, I removed all the bolts and captive nuts that hold the fender in place along the hood edge. The bolt holes were welded in, then ground flush and fill... | |
| Doors | 2008-08-23 | 2 | More body mods: Since I am using Harley mirrors that mount to the wind wing, I welded up the mirror holes in the door. I also welded in the door lock hole. Doors are now ni... | |
| 4-link | 2008-08-11 | 2 | My Guzman 4-link arrived today- SWEET! I hope I can get to install it this weekend. | |
| Mirrors | 2008-08-03 | 5 | I don't mind the look of the stock mirrors, but they do leave a bit to be desired as far as viewing area. So I have been looking for alternatives. The current options are: R... | |
| Trunk Lid Fit | 2008-08-03 | 3 | The trunk lid also didn't fit quite right- zero gap at one point and non-flush surfaces at a couple more areas. So back with the hammer, grinder and filler. Now it all fits correct... | |
| Tail Lights | 2008-07-20 | 3 | The sheet metal around the tail lights didn't fit too well either- large gaps and the light frames don't sit flush to the body all around. After I filled and blended, the lights no... | |
| Door Seams | 2008-07-06 | 6 | After all the body panels were installed and the doors hung, I measured the gaps around the doors. They varied from approximately 1/8" to 3/8", and the door skins weren't flush to ... | |
| Door Openings | 2008-07-02 | 5 | Since things are already getting out of hand welding up all the body seams, I thought I would seal up the gap between the front fender and the inner fender (at the front edge of th... | |
| Front Left Fender Completed | 2008-02-23 | 3 | Whoo-hoo! I finished blending in the front left fender this weekend, and primed it after finishing. Things are starting to come together! | |
| Fender Vents | 2008-02-12 | 6 | To keep the heat down in the engine compartment, I am installing vents in the fenders. I like the portholes (ventiports) from the 61 Buicks, and after much searching, I have enough... |
The contents of this journal entry (including entry images) are released
under the terms of the Creative Commons License unless otherwise noted.
under the terms of the Creative Commons License unless otherwise noted.
This page last modified December 01 2007 20:50:32 pm
Add a comment to this journal entry:
Please sign in if you already have an account or register now to enable this feature.