Journal Entry
 |
Visit GILBERT (Gil) DUPRE (ret Electrical Engineer)'s Profile. Subscribe to this Journal: 
What is RSS?
There are 80 entries in this Journal. Status: Member Location: CHATTANOOGA, TN, USA |
|
Dash Air Vent
Created on 2008-06-04 19:58:00
Today I got my AC hose adaptors for the In Dash vents. The trick was how do you remove the vents. I tried prying out to no avail. Took out glove box to look and feel. Couldnt see anything with mirror or feel anything with nimble fingers. Went back to the front and rotated vent grills and low and behold there one the bottom sides of each vent was a little tab. Put thin putty knife under the vent bottom edge and the put then blade screwdriver unde tabs to tilt outward while prying on the putty knife. they popped out easily then from the bottom. Photos to follow
Summary of Previous Journal Entries
Showing previous 10 journal entries:
| Title | Date | #Pic | #Cmt | Excerpt |
|---|---|---|---|---|
| Moss AC Kit In 74.5 | 2008-05-31 | Well I believe I have it cooling as well as can be expected at 1400 rpm low press is about 35 and high is about 175 psi. at 2500 rpm and above low press drops to about 30 and high... | ||
| Audiovox Cruise Control | 2008-04-17 | 1 | I finally connected all the wires that I left hanging from last fall while I installed the Moss AC. Today I took it out and checked the cruise control and man will that be nice thi... | |
| Moss AC Kit In 74.5 | 2008-02-02 | 1 | Finished editing the proceedure I used to get the kit to work in the 74.5 GT. More than 12 hours and more $$$$. Maybe I can trade something for it from Moss hahahaha. | |
| Got It Running | 2008-01-27 | Got the carb fuel leak fixed thanks to Jimmie then found a hose leaking. Got it fixed. started it up and drove around the block was running rough. Lots of dust needs clean... | ||
| Fired Up MGA | 2008-01-14 | After in paint for 2 months I decided to start it up. I have to take it back for color sand and compound. Battery was dead charged for two days no luck. Put on booster battery and ... | ||
| MGA Fender Piping | 2008-01-02 | Got one side of new piping fitted with slots cut for fender mtg bolts. Next re aligning fender to door and body and bolting down. What a job. | ||
| MC Replacement | 2008-01-01 | I completed the MC and Clutch MC replacement and took it for test drive. Clutch works great but I need to maybe bleed brakes again. | ||
| Brakes | 2007-12-30 | Finished brake and clutch MC's replacement. SS brake and clutch hoses and both master cylinders. Replaced fluid with silicone dot 5 fluid. Flushed and bled all lines. | ||
| SS Brake Line | 2007-12-23 | Well today I made more progress. I installed the driver side ss brake line. One day or days I will have to replace the front suspension rubber. It is still there after 33 years. A... | ||
| New Brake Line | 2007-12-11 | Today I installed the new ss brake line on the front passenger side. It looks like it will be long enough. Getting it to loop up and to the rear was finally accomplished by adjusti... |
The contents of this journal entry (including entry images) are released
under the terms of the Creative Commons License unless otherwise noted.
under the terms of the Creative Commons License unless otherwise noted.
This page last modified December 01 2007 20:50:32 pm
Add a comment to this journal entry:
Please sign in if you already have an account or register now to enable this feature.